Irfora PLA-LW Weight PLA 3D Printer Filament Low Density Strong Paint Adhesion 1.75mm 1KG Spool Foaming PLA Filament for 3D Printers 3D Printed Airplane

drones, and COSPLAY props. Specifications: Model: ePLA-LW Color: Natural Outside Diameter: 1.75mm Recommended Printing Temperature: 190-270℃ Unformed Printing Temperature: 190-210℃ Foaming Printing Temperature: 210-270℃ Maximum Foaming Rate(270℃): 122% Lowest Extrusion Rate(270℃): 45% Bed Temperature: 45-60℃/ No Heat Printing Speed: 40-80mm/s Item Weight: 1488g/4.3lbs Printing Precautions 1. Note that the first layer speed setting is consistent with the actual printing speed, set to 100% of the actual printing speed, turn off the first layer, small area printing speed reduction function, the first layer extrusion rate is consistent with the actual foaming extrusion rate, such as 270 degrees Set the first layer extrusion rate to 45%; if the bottom plate adhesion is too b, you can set the bottom valve when printing; 2. Pay attention to the maximum work temperature of the printer. Most Teflon tube printers cannot work for a long time above 250°C. Long-term printing above this temperature may cause clogging. If the temperature exceeds 250°C, metal throat are required for printing; 3. Yellowing of printed models after high temperature foaming is a normal phenomenon, and lowering the printing temperature can alleviate it. 4. Since the weight PLA foams continuously in the melting cavity of the high-temperature nozzle, the retraction basically does not work, so stringing is normal when nozzle crossing outline. It is recommended to print the vase mode airplane model to reduce the influence of the stringing on the model. 5.Foaming ratio is related to temperature, printing speed, nozzle melting cavity size, Please set wall thickness, adjust extrusion rate/temperature/speed and other parameters by comparing different models according to your own printing situation. Package List: 1 Roll * PLA Filament

• weight & Low Density: ePLA-LW has applied active foaming technology, density is only 0.54g/cm3. The highest foaming ratio is 220%, and when printing the same model, 1 roll of ePLA-LW can be used as 2.2 rolls of ordinary PLA.
• Clog-free & No Warping & Less-tangle: Full al winding and strict manual examination ensure tangling free and filament breaking and snapping.
• Good Interlayer Adhesion & Matte Printing Effect: Compared to wood PLA filament,ePLA-LW filament has more stable interlayer adhesion, and the foaming rate and strength can be controlled by adjusting the printing temperature between 210℃-270℃.
• Foaming When Printing: For same model and printing speed, ePLA-LW enables the model aircraft to have a er wing load and a lower stall speed. It also has a strong adhesion of surface paint. So it is a perfect choice for printing model airplanes, drones, and COSPLAY props.